Resetting Limits on GDO6v4

Is your door not responding? Do you need to reset limits on your GDO-6 V.4? Follow these steps

The control panel is below the light of the motor

  1. Erase limits
    • Depress SET and unplug motor at the same time
    • Continue holding SET and plug the motor in again
    • Hold SET until the repeating twitter has stopped
  2. Pull red cord – dis-engage motor
  3. Pull curtain down to half open
  4. Pull red cord – re-engage motor
  5. On the Motor find the Red (-) and Green light (+)
    **If the motor is mounted on the left side of the door – press OPERATE button once to change direction
  6. The Red light MINUS (-) button should be flashing
  7. Press MINUS until the door is closed tight, but not hard
  8. Press SET once
  9. The GREEN light PLUS (+) button should be flashing
  10. Press PLUS until the door is just short of the STOPPER
  11. Press SET once again

Now the door will automatically complete a full revolution (down then up)

*To download the PDF guide, click here

Watch the video